Unified Auto Bed Leveling UBL

Is it possible to use the AUTO_BED_LEVELING_UBL in the firmware?

No idea. Never tried.

Does the Firmware save the values of the auto bed leveling in the eprom so that I could retrieve it with the start code G28 L0?

What’s that? You mean G29 L0 probably.

Yes, the mesh is saved.

Oh yes sorry, I mean G29 L0.

I don’t like the ABL bevor every print (start g-code G29).
Is it possible to restore the mesh from the eprom in the start g-code?

This is not done by the firmware, only by your startup G-Code

M420 S1

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.