Strange X and Y movement when starting preheat on ver 4.0.3

Hi!

I recently installed version 4.0.3 on my Wanhao Duplicator I3 Plus. Whenever I start a preheat after turning on the printer (using the display) there is always a couple of seconds of really slow X and Y movement before preheat is initiated. This is not a dynamic error, it happens every time.

/Tobias

Strange. Do you install from the stock firmware or from another version of ADVi3++?

I installed from ADVi3++ ver 4.0.1

Don’t know if its any help but I too experienced the problem described in the topic " Bug. Move option after stopping printing" when using ADVi3++ ver 4.0.1. I have not yet checked if this problem is gone in ver 4.0.3