Negative extrusion distance?

Not an issue per se, just wondering if it’s possible to include in a future release? Just installed a new motor and flexion, and hoo boy, they were not kidding about the torque increase. I had to dial back nearly 10cm - which took a bit of doing with a min value of zero on the calibration screen.

For new feature suggestions, please create an issue on GitHub:

I am not sure to understand what you suggest (what means “Negative extrusion distance”), but looks like it is already covered by:

1 Like

Awesome. By neg i mean on the extruder tuning - if your stepper goes 15cm on a 12cm extrusion, then your value is -3