Is setting linear advance K value in motor settings all that needs to be done to enable it?

I’m on a Monoprice Maker Select Plus running ADVi3++ v. 4.0.6 and Marlin 1.1.9.

I’ve printed the Marlin K factor test print and for my extruder I need to set a K factor of 0.2.

If I set it in Tuning → Motor Settings → Linear Advance, is it automatically enabled for all prints?
Or do I need to enable it in my slicer as well? I’m using the most recent build of Cura.

Thanks! I couldn’t find an answer to this in the forum via search.

Yes.

1 Like

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.