Impossibile change junction deviation on Advi3+ 5.0.0 or 5.0.1

On Advi3 5.0 it’s impossibile to change junction deviation value, the value that I enter is accepted but later it is always overwritten by 0.3… I tried with everything value but without success… I’m now on Advi3 5.0.1 on wanhao i3 plus but even on 5.0.0 i had same problem, thank you

I will look at it. Thanks for reporting.

Thank you so much Sebastian

This topic was automatically closed 10 days after the last reply. New replies are no longer allowed.