Default Settings

The default parameters of this firmware are the following:

Step Settings Default value Remark
X 80 was 81 before 3.0.2
Y 80 was 81 before 3.0.2
Z 400 was 400.5 before 3.0.2
E 93.0 was 94.30 before 3.0.2
PID Settings Default value Remark
P 33.41
I 1.47
D 189.27
Feedrate Settings Default value Remark
Max X 450
Max Y 450
Max Z 20
Max E 25
Min 0
Travel 0
Acceleration Settings Default value Remark
Max X 1000
Max Y 1000
Max Z 100
Max E 1000
Print 800
Retract 800
Travel 800
Jerk Settings Default value Remark
X 8
Y 8
Z 0.4
E 1.0

I’ve just updated from 3.0.2 to 4.0.2 and reset all settings to default. Just checking the default paremeters above with what my machine tells me and I’ve noticed that the Feedrate Max Z setting is 20 (in my machine) and not 5 as recorded here? Is this just a typo here or something else? Following on from this, what should the correct setting be?

Yes, this is a typo in the manual

2 Likes