ADVi3++ Get Help


Topic Replies Activity
READ ME FIRST: rules about posting here 1 May 31, 2019
Powerspec i3 plus w/ Bltouch rams buildplate after one successful print 6 November 19, 2019
Bug. Move option after stopping printing 6 November 19, 2019
ADVi3++ v4.0.3 No images for LCD in "DWIN_SET" folder 2 November 19, 2019
Automatic leveling - First point starts outside bed 1 November 18, 2019
Using DGUS to modify the interface 12 November 17, 2019
Upgrade to Thermistor 7 November 14, 2019
Octopi into and progress display 2 November 13, 2019
Wiping the screen firmware completely out 8 November 13, 2019
Extruder Problem in 4.0.3 with BLtouch on Monoprice Maker Select Plus 12 November 12, 2019
Version 4.0.3. Installation issue, LCD not matching board 1 November 11, 2019
Filament runout sensor 10 November 10, 2019
Wanhao Duplicator i3 Plus Mark II & BLtouch v3 3 November 9, 2019
BLTouch3 one side lower than other 8 November 1, 2019
Extruder motor will not feed after flashing BLTouch firmware (Maker Select Plus 15711) 52 October 30, 2019
Z endstop not working after installing 3.0.2 and version 4 11 October 30, 2019
Touchscreen Flash not working 3 October 29, 2019
Change TEMP_0_PIN 1 to 2 in firmware 11 October 28, 2019
Enabling Manual Bed Leveling (No probe) 7 October 27, 2019
Slow Printing After Power Cycle 9 October 26, 2019
BLTouch3 Fail (plz halp! - video included) 7 October 18, 2019
I3 Plus not extruding after BLTouch upgrade. (Video included of issue) 4 October 15, 2019
Changing BLTouch mount preset offsets(e.g. Indianagio mount) 3 October 12, 2019
After installing 4.0.3 z axis height is wrong 9 October 12, 2019
Extruder temp reading 262-266 constantly 4 October 12, 2019
X and Y axis some times moves on their own 12 October 10, 2019
TMC2130 support (Balco 3D Printer Touch) 2 October 6, 2019
Looking for a correct diagnosis screen image 2 October 6, 2019
Bontech extruder motor colliding with x axis support on right side 8 September 25, 2019
BLTouch Probes to far forward and not far enough back 4 September 24, 2019